What's actually causing this
Dryers stop heating when the thermal fuse blows (a safety device triggered by overheating), the heating element fails, the gas supply is interrupted, or a clogged vent causes the unit to overheat and shut off.
What you'll need
Links go to Amazon search results — buy the part that matches your specific model. Uncle AI earns a small commission on purchases, at no extra cost to you.
- Multimeter Shop →
- Thermal fuse replacement Shop →
- Dryer vent cleaning kit Shop →
- Screwdriver set Shop →
- Heating element Shop →
Step-by-step fix
-
1
Clean the lint trap and vent hose
Remove and clean the lint screen. Then disconnect the vent hose from the back and run a vent cleaning brush through the full length of the duct to the exterior. A clogged vent is the most common cause of dryer overheating and thermal fuse failure.
-
2
Check the circuit breaker (electric dryers)
Electric dryers run on a 240V circuit with two breaker switches. If one trips, the drum tumbles but there's no heat. Reset both breakers — flip them fully off then back on.
-
3
Test the thermal fuse
Unplug the dryer. Access the back panel and locate the thermal fuse on the exhaust duct. Test with a multimeter set to continuity — no continuity means it's blown and needs replacing.
-
4
Replace the thermal fuse
The fuse is held by two screws and two wires. Take a photo before disconnecting. Replace with a matching fuse (check your model number). Don't bypass the fuse — it's a safety device.
-
5
Test the heating element (if fuse was fine)
The heating element is a coiled wire inside the back panel. Test each terminal with a multimeter for continuity. A break anywhere in the coil means it needs replacing.
Appliance technicians in Atlanta typically charge $55–115/hr for service calls and repairs. Major appliance replacement costs $500–2,000+ per unit.
Standard U.S. sizes. Gas heat common. Washer/dryer hookups standard. Venting straightforward.
High humidity can promote mold growth in washing machines and dishwashers. Leave doors ajar between cycles and run cleaning cycles monthly.
Appliance costs in Atlanta are near or below national averages, making replacement a more viable option when repair costs exceed 50% of a new unit.
DIY in Atlanta: Atlanta's moderate licensing requirements and growing DIY culture make it reasonably friendly for homeowner repairs. Humidity management and moisture prevention are key DIY focuses. Most people hire contractors for major electrical and HVAC work.
- You've replaced the thermal fuse twice in a short period — the root cause isn't fixed.
- The dryer makes a loud squealing or grinding noise.
- It's a gas dryer and you smell gas.
- The drum doesn't turn at all — likely a broken belt or motor.
Let Uncle AI diagnose it first.
Describe the problem. Uncle AI asks the right questions and tells you exactly what's broken — and whether you should fix it yourself or call someone in Atlanta.
Start free diagnosis →