What's actually causing this
Dryers stop heating when the thermal fuse blows (a safety device triggered by overheating), the heating element fails, the gas supply is interrupted, or a clogged vent causes the unit to overheat and shut off.
What you'll need
Links go to Amazon search results — buy the part that matches your specific model. Uncle AI earns a small commission on purchases, at no extra cost to you.
- Multimeter Shop →
- Thermal fuse replacement Shop →
- Dryer vent cleaning kit Shop →
- Screwdriver set Shop →
- Heating element Shop →
Step-by-step fix
-
1
Clean the lint trap and vent hose
Remove and clean the lint screen. Then disconnect the vent hose from the back and run a vent cleaning brush through the full length of the duct to the exterior. A clogged vent is the most common cause of dryer overheating and thermal fuse failure.
-
2
Check the circuit breaker (electric dryers)
Electric dryers run on a 240V circuit with two breaker switches. If one trips, the drum tumbles but there's no heat. Reset both breakers — flip them fully off then back on.
-
3
Test the thermal fuse
Unplug the dryer. Access the back panel and locate the thermal fuse on the exhaust duct. Test with a multimeter set to continuity — no continuity means it's blown and needs replacing.
-
4
Replace the thermal fuse
The fuse is held by two screws and two wires. Take a photo before disconnecting. Replace with a matching fuse (check your model number). Don't bypass the fuse — it's a safety device.
-
5
Test the heating element (if fuse was fine)
The heating element is a coiled wire inside the back panel. Test each terminal with a multimeter for continuity. A break anywhere in the coil means it needs replacing.
Appliance technicians in San Diego typically charge $65–125/hr for service calls and repairs. Major appliance replacement costs $500–2,000+ per unit.
Standard U.S. sizes. Gas ranges common. Washer/dryer hookups standard. Venting straightforward.
Hard water in San Diego (180–250 ppm) accelerates scale buildup in dishwashers, washing machines, and water heaters. Consider a water softener or descaling treatments every 3–6 months.
DIY in San Diego: San Diego is moderately DIY-friendly. California's licensing is strict, but homeowner exemptions exist for simple work. Coastal property owners should hire professionals for salt-corrosion-prone work. UV and salt protection are common DIY focuses.
- You've replaced the thermal fuse twice in a short period — the root cause isn't fixed.
- The dryer makes a loud squealing or grinding noise.
- It's a gas dryer and you smell gas.
- The drum doesn't turn at all — likely a broken belt or motor.
Let Uncle AI diagnose it first.
Describe the problem. Uncle AI asks the right questions and tells you exactly what's broken — and whether you should fix it yourself or call someone in San Diego.
Start free diagnosis →