What's actually causing this
Ice makers stop working when they can't get water (kinked line, closed valve, frozen inlet), when the unit is switched off, or when the ice bin is full and blocking the sensor arm.
What you'll need
Links go to Amazon search results — buy the part that matches your specific model. Uncle AI earns a small commission on purchases, at no extra cost to you.
Step-by-step fix
-
1
Check that the ice maker is switched on
Locate the wire arm on the ice maker — if it's flipped up, the unit is off. Lower it to the down position. Some models have a power switch on the front of the ice maker instead.
-
2
Check the water supply valve
Pull the fridge away from the wall. Find the saddle valve or shut-off valve on the water supply line behind the fridge. Make sure it's fully open.
-
3
Check for a frozen water line
If the water supply line entering the ice maker is frozen, use a hair dryer on low heat to thaw it. Keep the dryer moving — don't hold it in one spot.
-
4
Replace the water filter
A clogged water filter restricts flow enough to stop ice production. Most filters need replacing every 6 months. The filter location is usually inside the fridge or in the base grille.
-
5
Reset the ice maker
Most ice makers have a reset button on the front or underside of the unit. Press and hold for 3–5 seconds. Give the unit 24 hours to start producing ice after a reset.
Appliance technicians in Denver typically charge $65–125/hr for service calls and repairs. Major appliance replacement costs $500–2,000+ per unit.
Standard U.S. sizes. Gas heat very common. High altitude affects boiling points and cooking. Washer/dryer hookups standard. Venting straightforward.
Standard maintenance schedules apply for Denver's climate.
DIY in Denver: Denver's moderate licensing and outdoor-focused culture support DIY repairs. Freeze-thaw maintenance and seasonal winterization are common homeowner tasks. High altitude knowledge is helpful. Most people hire professionals for electrical and HVAC work.
- Water is leaking onto the floor from the ice maker.
- You hear the ice maker cycling but no ice is produced and the lines are clear.
- The ice tastes or smells bad even after replacing the filter.
- The water inlet valve is visibly cracked or corroded.
Let Uncle AI diagnose it first.
Describe the problem. Uncle AI asks the right questions and tells you exactly what's broken — and whether you should fix it yourself or call someone in Denver.
Start free diagnosis →