What's actually causing this

Window panes break from impact, stress fractures from temperature cycling, or settling of the window frame. Single-pane windows in older homes are the most common repair candidate.

What you'll need

Links go to Amazon search results — buy the part that matches your specific model. Uncle AI earns a small commission on purchases, at no extra cost to you.

Ad Slot — In-Content

Step-by-step fix

  1. 1

    Remove the broken glass

    Wearing thick gloves, remove the largest pieces first. Score remaining shards with a glass cutter and snap them out. Dispose in a puncture-proof container.

  2. 2

    Remove old glazing compound

    Use a heat gun or hair dryer to soften old glazing putty, then scrape it away with a putty knife. Remove all glazing points with pliers.

  3. 3

    Measure and order new glass

    Measure the opening and subtract 1/8 inch from each dimension to allow for expansion. Take these measurements to a hardware store for cutting.

  4. 4

    Bed and set the new glass

    Apply a thin layer of glazing compound in the channel as a bed. Set the glass and press it firmly. Insert glazing points every 6 inches to hold the glass in place.

  5. 5

    Apply glazing and paint

    Roll glazing compound into a rope and press it against the glass at a 45-degree angle using a putty knife. Smooth it flush. Let dry 7 days before painting.

What this costs in Denver
DIY (parts only) $20–80
Hiring a local pro $150–400
Cost of doing nothing Energy loss, weather damage, and security risk
Doors and windows in Denver homes

Door and window contractors in Denver typically charge $85–145/hr. Window replacement averages $300–800 per window, while entry doors run $800–2,500 installed.

Permits and inspections requirements vary by Denver. Check with your local building department before starting.

Brick, stucco, and wood siding common. Asphalt shingles perform well in dry climate. High altitude UV exposure requires quality paint and sealants. Freeze-thaw cycles cause expansion cracking.

Freeze-thaw cycles in Denver stress window seals, weatherstripping, and door frames. Check for drafts annually and replace worn weatherstripping before winter. Intense UV exposure in Denver degrades window seals, fades finishes, and warps exterior doors. Low-E glass and UV-resistant finishes extend service life significantly.

DIY in Denver: Denver's moderate licensing and outdoor-focused culture support DIY repairs. Freeze-thaw maintenance and seasonal winterization are common homeowner tasks. High altitude knowledge is helpful. Most people hire professionals for electrical and HVAC work.

Stop and call a pro if you see this
  • The window is double-pane (foggy between panes means the seal is gone).
  • The glass is tempered, laminated, or has embedded wires.
  • The window frame is rotted — the glass replacement won't hold.
  • The window is larger than 3 square feet — large glass is difficult to transport and install safely.
Not sure what's wrong?

Let Uncle AI diagnose it first.

Describe the problem. Uncle AI asks the right questions and tells you exactly what's broken — and whether you should fix it yourself or call someone in Denver.

Start free diagnosis →
Ad Slot — 728×90 Footer Leaderboard