What's actually causing this
Furnaces fail to heat when the filter is clogged (causing overheating and shutdown), the pilot light or ignitor has failed, the thermostat is misconfigured, or the system enters a safety lockout due to a repeated ignition failure.
What you'll need
Links go to Amazon search results — buy the part that matches your specific model. Uncle AI earns a small commission on purchases, at no extra cost to you.
Step-by-step fix
-
1
Check the thermostat
Set it to HEAT, set the temperature 5 degrees above room temperature, and confirm the fan is set to AUTO. Replace batteries if the display is dim.
-
2
Check the filter
A clogged filter causes the furnace to overheat and shut down on a safety limit. Replace the filter if it's gray and dense.
-
3
Check the circuit breaker
Find the furnace breaker in the panel. Reset it if tripped. Also check the furnace power switch (looks like a light switch near the unit).
-
4
Read the diagnostic LED
Open the furnace access panel and find the small LED on the control board. Count the blinks — most furnaces include a blink code chart on the inside of the panel door.
-
5
Check the condensate drain (high-efficiency furnaces)
High-efficiency furnaces produce condensation. If the drain is clogged, the furnace shuts down. Find the PVC drain line and clear it with a wet/dry vac.
HVAC technicians in Tampa typically charge $100–160/hr. Annual maintenance runs $150–300, while furnace or A/C replacement costs $4,000–8,000+.
Florida requires state licensing. Homeowner exemptions do not apply.
Central air runs year-round. Dehumidification is critical. Many homes oversized for cooling. Hurricane ties required. Maintenance is frequent due to hard use.
Tampa's high humidity creates persistent moisture challenges for HVAC systems. Expect to clean or replace filters more frequently. Condensation on ductwork, drain line clogs, and mold in air handlers are common issues. Dehumidification capacity matters here.
DIY in Tampa: Tampa's strict Florida licensing, hurricane codes, and environmental hazards restrict DIY repairs. Hire licensed professionals for plumbing, electrical, and HVAC. Coastal humidity and salt air require specialized knowledge.
- The furnace ignites but shuts off within 30 seconds — flame sensor issue requiring a tech.
- You smell gas — leave the house and call the gas company.
- The furnace is making loud banging or scraping sounds.
- The blink code indicates a pressure switch or inducer motor fault.
Let Uncle AI diagnose it first.
Describe the problem. Uncle AI asks the right questions and tells you exactly what's broken — and whether you should fix it yourself or call someone in Tampa.
Start free diagnosis →