What's actually causing this
Electric water heaters lose heat when a heating element burns out or the thermostat fails. Gas heaters fail when the pilot light goes out, the thermocouple wears out, or the gas valve malfunctions.
What you'll need
Links go to Amazon search results — buy the part that matches your specific model. Uncle AI earns a small commission on purchases, at no extra cost to you.
- Multimeter Shop →
- Heating element wrench Shop →
- Replacement heating element Shop →
- Flathead screwdriver Shop →
Step-by-step fix
-
1
Check the circuit breaker
Go to your electrical panel and look for a tripped breaker labeled 'water heater.' Reset it and wait 30 minutes to see if hot water returns.
-
2
Check the pilot light (gas heaters)
Look at the pilot light window on the front of the tank. If the pilot is out, follow the manufacturer's relighting instructions on the label.
-
3
Test the heating elements (electric heaters)
Turn off power at the breaker. Remove the access panel on the side of the heater and test each element with a multimeter set to ohms. A reading of 0 or infinity indicates a failed element.
-
4
Replace the failed element
Drain the tank, unscrew the failed element with a heating element wrench, and install the replacement. Refill before restoring power.
-
5
Check the thermostat setting
The thermostat should be set to 120°F (49°C). Higher settings can cause scalding; lower may feel cold. Adjust and wait 1 hour.
In Indianapolis, tap water is very hard (280–370 ppm). Indianapolis has very hard water. Mineral deposits accumulate rapidly. Water softeners are nearly universal. Hard water significantly reduces water heater lifespan to 7–9 years.
Plumbers in Indianapolis typically charge $80–135/hr. Most homeowners budget $800–2,500 for common repairs like fixture replacement, drain clearing, or valve repairs.
Indiana requires state licensing for master plumbers. Indianapolis requires permits. Homeowner exemptions limited.
Mix of pre-1950s and post-1980s construction. Older homes may have galvanized piping. Very hard water means water softeners nearly universal. Freeze-thaw cycles cause burst risk. Copper replacement common.
Indianapolis winters regularly bring freezing temperatures. Pipe freeze risk is real, especially in older homes with uninsulated exterior walls. Heat tape and foam insulation on exposed pipes are worthwhile investments. Know where your main water shutoff is before winter.
DIY in Indianapolis: Indianapolis is very DIY-friendly with the lowest labor costs among major metros. Affordable permitting and inspections support homeowner work. Very hard water management and freeze prevention are common DIY focuses.
- The tank is leaking from the base — this means the tank has failed internally and needs full replacement.
- The unit is over 12 years old — replacement is more cost-effective than repair.
- You smell rotten eggs (gas smell) — leave the house and call the gas company immediately.
- The pressure relief valve is releasing water — this is a safety issue requiring professional diagnosis.
Let Uncle AI diagnose it first.
Describe the problem. Uncle AI asks the right questions and tells you exactly what's broken — and whether you should fix it yourself or call someone in Indianapolis.
Start free diagnosis →